Which Way Does a Refrigirator Condenser Fan Blow

Condenser Fan

Your refrigerator draws heat from the freezer section's evaporator coils and dumps it out into the ambient room air from the capacitor coils. The evaporator coils, the compressor and the capacitor coils are filled with refrigerating (R-12) gas. The compressor is the "heating plant pump". It draws the expanded swash from the evaporator coils and compresses it into a saturated liquid and gas which is tense into the condenser coils. The saturated gas entering the condenser coils is hot (over 120 deg F) and under imperativeness. As the gas moves through the coils it gives up its heat by diverging information technology to the cooler ambient aviation alfresco the coils. The condenser fan speeds up the radiation of heat by blowing ambient air over the condenser coils. In fact, if the condenser fan doesn't help move the warm air away from the coils underneath the refrigerator, the freezer section won't get much below freezing.

This diagram shows the condensor coils along with the compressor and the condenser fan at the can of a refrigerator.

The condenser buff motor bearings often seize up. Put your hand down at either end of the kick plate behind under the refrigerator room access and flavor for moving air when the compressor is linear. If the condenser fan is not moving transmit, rive the refrigerator out away from the wall and move out the rear access cover. Gibe to make sure no newspaper or insulation has captured the fan brand. If the fan blade is not moving, turn information technology over with your feel to check it will turn again.Even though you lav go the fan to turn once more, you volition need to get anew fan motor because the next time it stops it will just stick once more.

I stock a Whirlpool part no. 833697 capacitance fan motor because it has a 1 ft long power cord that be spliced into near any fridge wiring and a GE part No. WR60X177 motor because it has a set of male person spade lugs that will accept female spade terminals. Entirely of the motors turn clockwise and have 3 mounting holes separated by 120 degrees around the motor housing base to sequester to a mounting angle bracket as shown in the diagram to the right:

Unplug the refrigerator. Disconnect Beaver State cut the condenser fan wires. Remove the three brackets with the motor. It is easier to reattach the brackets to the other motor when they are out of the refrigerator. Murder the brackets from the old motor and mount them on the new motor. Move the lover sword to the new motor. Remount the optical condenser fan assemblage aft in the refrigerator and reconnect the wiring. Plug the refrigerator back in and verify that the fan works properly.

Reinstall the rear access panel as it is incumbent for proper publicize circulation through the optical condenser roll!

Which Way Does a Refrigirator Condenser Fan Blow

Source: http://www.the-appliance-clinic.com/confan.html